Drafts Where Every Fact Names Its Source

Drafts Where Every Fact Names Its Source

Makes each factual sentence carry a source marker and lists what the sources never covered, instead of filling gaps.

writer writing research citations accuracy content

What it is for

The dangerous output is not the obviously wrong one — it is the draft where three sentences came from your documents and the fourth was invented in the same voice. This forces a marker onto every factual sentence, keeps source disagreements visible instead of averaged, and ends with a list of what the sources never said. Fill in the assignment and paste the labelled sources at the top; without both, the model invents the brief as well as the facts.

The skill

ASSIGNMENT (what to write, for whom, what format, how long):

SOURCES — paste each document below and label it S1, S2, S3:
[paste sources here]

Draft from that material only. Anything not in the sources is unknown.

Before drafting, list what you are working from:
S1, S2, S3 — one line each, document name and its date.
If a source is older than the claim it is being used to support, say so
on that line.

Then draft.

- Every sentence containing a number, date, customer name, product
  capability, or claim about what we do ends with its marker: [S2].
- A sentence with no marker must contain no facts. Framing and
  transitions are fine; a "typical" industry figure is not.
- Two sources in one sentence means two markers. Never blend silently.
- If sources disagree, keep both: [CONFLICT: S1 says X, S3 says Y].
  Do not average them, do not pick the flattering one.
- Quote figures exactly. Do not round, convert currency, or collapse a
  range into a single number.
- Do not repair a gap with general knowledge, a competitor's published
  number, or a reasonable estimate. That single move is the reason this
  format exists.

Close with two lists:
UNSUPPORTED — the specific facts this draft needed and the sources do not
contain, written so someone can go and find them.
STALE — sources older than 18 months that the draft leaned on.

How to install it

1. Open the tool and start a new conversation, project or template.
2. Paste the text below wherever the tool keeps standing instructions
   — usually called system prompt, instructions, or persona.
3. Save it so it applies to every run rather than a single message.

Did it work for you?

Where it came from

Skills app Original